Hi,
I am running the custom firmware version 4.1.3, and this morning the box will not boot up. It doesn't' say BOOT, but goes straight to 'Custom Firmware_4_1_3' on the front panel', and all buttons are unresponsive as is using the remote. I've removed the network, HDMI and satellite aerial cables.
So I've tried:
1. Turning off at the back, leaving for a minute or two, turning back on. I can hear the disk starting then the box stops - just displays as above.
2. Pulling plug out, same thing happens
3. Inserting a USB into the front with the custom firmware load & trying to flash as reinstall. This appears to run successfully, but it doesn't properly go into standby and is back to completely unresponsive & 'Custom Firmware_4_1_3' on the front panel'
Appreciate some help here - based on description - is there any way I can tell if it is disk or unit failure, or something else?
Thanks in advance.
I am running the custom firmware version 4.1.3, and this morning the box will not boot up. It doesn't' say BOOT, but goes straight to 'Custom Firmware_4_1_3' on the front panel', and all buttons are unresponsive as is using the remote. I've removed the network, HDMI and satellite aerial cables.
So I've tried:
1. Turning off at the back, leaving for a minute or two, turning back on. I can hear the disk starting then the box stops - just displays as above.
2. Pulling plug out, same thing happens
3. Inserting a USB into the front with the custom firmware load & trying to flash as reinstall. This appears to run successfully, but it doesn't properly go into standby and is back to completely unresponsive & 'Custom Firmware_4_1_3' on the front panel'
Appreciate some help here - based on description - is there any way I can tell if it is disk or unit failure, or something else?
Thanks in advance.
Last edited: